TP LINK TL WN321G 54M WIRELESS USB ADAPTER DRIVER

Operation is subject to the following two conditions: Click the Finish button to finish the wizard. Link Quality – Shows the quality of the signal.. It means the utility is running on your system. The Profile screen provides tools to:

Uploader: Arashiran
Date Added: 8 January 2015
File Size: 9.65 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 62170
Price: Free* [*Free Regsitration Required]

Figure Advanced Wireless mode – Displays the wireless mode, either Click Activate on the Profile screen.

The default setting wirelesd Auto Switch access point modewhich allows both short and long headers in the You can turn the wireless radio off by selecting the check-box. Increase the separation between the equipment and receiver. Connect one end of the USB cable to the Adapter.

Click the Profile tab of the utility and click the Add button on the screen that appears. Do not forget to click the Activate button when you create a new profile for connection.

Download for TL-WNG | TP-Link

The Profile Management dialog box will display a screen similar to that shown in Figure The adapter can only use short radio headers if the access point supports and uses them. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: In infrastructure mode, the wireless devices communicate with each other and to a wired tp link tl wn321g 54m wireless usb adapter by first going through an access point.

New Drivers  PM39LV010 DRIVERS FOR WINDOWS 7

Default Gateway – The default gateway of the wireless network. This device adaoter its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

WN321G 54 Mbps Wireless USB Adapter User Manual TL-WN321G 1.0 TP-Link Technologies Co., Ltd.

Changes or modifications to this tp link tl wn321g 54m wireless usb adapter not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. It can also interoperate with all 11Mbps wireless The utility will establish a connection with this AP by configured profile. Utility Date – The creation date of this utility.

Click OK to save this profile. The following setup steps are for windows The Profile screen provides tools to: After installing the driver successfully, you should see an icon, system tray. SubMask – The subnet mask of the wireless network.

TP-Link TL-WNG 54Mbps Wireless USB Adapter TL-WNG B&H

However, there is no guarantee that wirelees will not occur in a particular installation. This field determines which operating frequency will be used. Apply – Click the Apply button to save the current setting. Even if one or more bits in the chip are damaged during transmission, statistical techniques embedded in the receiver can recover the original data without the need for retransmission.

New Drivers  F5D7000 BELKIN DRIVER FOR WINDOWS

Please follow the Install Shield Wizard steps, the system will uninstall the utility software from your PC automatically. To an unintended receiver, DSSS appears as low power wideband noise and is rejected ignored by most narrowband receivers.

You can click the Next button to continue the Installation. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. If you want to use Windows XP to configure wireless network settings, you should exit the utility.

Spread Spectrum – Spread Spectrum technology is a wideband radio frequency technique developed by the military for use in reliable, secure, mission-critical communications systems. Click Back to return to the previous page, or click Cancel to end the Installation. The test was performed according to the following European standards: